EasyManua.ls Logo

Bedfont NoxBox - Network Connections

Bedfont NoxBox
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
NOTE 1: U
T
istheA.C.mainsvoltagepriortoapplicationofthetestlevel
NOTE 2: At80MHzand800MHz,thehigherfrequencyrangeapplies
NOTE 3: These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorptionandreectionfromstructures,objectsandpeople.
TheISM(industrial,scienticandmedical)bandsbetween150kHzand80MHzare6.765MHzto6.795MHz;
13.553MHzto13.567MHz;26.957MHzto27.283MHz;and40.66MHzto40.70MHz.
ThecompliancelevelsintheISMfrequencybandsbetween150kHzand80MHzandinthefrequencyrange80
MHz to 2.5 GHz are intended to decrease the likelihood that mobile/portable communications equipment could
causeinterferenceifitisinadvertentlybroughtintopatientareas.Forthisreason,an
additional factor of 10/3 Is used in calculating the recommended separation distance for transmitters in these
frequency ranges.
Fieldstrengthsfromxedtransmitters,suchasbasestationsforradio(cellular/cordless)telephonesandland
mobileradios,amateurradio,AMandFMradiobroadcastandTVbroadcastcannotbepredictedtheoreticallywith
accuracy.ToassesstheelectromagneticenvironmentduetoxedRFtransmitters,anelectromagneticsitesurvey
shouldbeconsidered.IfthemeasuredeldstrengthinthelocationinwhichtheNOxBOX
i
is used exceeds the
applicableRFcompliancelevelabove,theNOxBOX
i
shouldbeobservedtoverifynormaloperation.Ifabnormal
performanceisobserved,additionalmeasuresmaybenecessary,suchasreorientingorrelocatingtheNOxBOX
i
.
Overthefrequencyranges150kHzto80MHz,eldstrengthshouldbelessthan3V/m.
2.5 Network Connections
Thedeviceisnottobeconnectedtoanetwork.
ThesystemisprovidedwithaUSBport.Thisissolelyforthepurposeofdownloadingsystemlogs
forrecordandanalysisbyasuitablyqualiedSystemsEngineer.
2.6 Applied Parts
Thesystemhasnoappliedparts.HowevertheNOxFlowandSampleLinearetreatedasapplied
parts(apartfromlabellingrequirements)asperBSEN60601-1:2006Section4.6.
2.7 Isolation from Mains
WARNING: Operator should not contact the patient whilst simultaneously being in
contact with the NOxBOX
i
device.
Shutdownofthesystemiscoveredinsection6.13Shutdown.
In order to isolate the system from the mains unplug the Mains Power Supply. Do not position the
systemsothatthisisdifculttodo.

Related product manuals