Belanger CUBE - Page 50

CUBE® CONTROLLER
6-4 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL964
Chapter 6 Operator Interface / Advanced Configuration
Setup / Advanced Configuration
Advanced Configuration / Application Configuration
ON Positions
FS = From Start (turns ON based upon the start position of the application).
FE = From End (turns OFF based upon the end position of the application).
Examples:
• FS 000 – Will turn ON immediately when application is started. Must be set to FS 000 to remain ON for full
time.
• FS 002 – Will turn ON at 2 inches from position that application is started.
• FE 002 – Will turn ON at 2 inches from position that application will eventually stop.
• FE 050 – Will turn ON at 50 inches from position that application will eventually stop.
OFF Positions
FS = From Start (turns ON based upon the start position of the application).
FE = From End (turns OFF based upon the end position of the application).
Examples:
• FS 050 – Will turn ON at 50 inches from position that application started.
• FE 000 – Will turn OFF at end position of application.
• FE 050 – Will turn ON at 50 inches from position that application will eventually stop.