INTEGRA® / E-1063
7-2 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL102
Chapter 7 Faults and Alarms
Faults
Fault Codes
RS-232 must be set to Modem before paging can occur.
No. Description of Problem
135 Roller up fault and Conveyor Jam
159 Photo Eye fault
183 Conveyor jam
190 VFD Fault
207 Roller up fault
208 Pump Water low
217 Hydraulic Tank 2 low
223 Input fault
238 Overload tripped
239 GFCI fault
243 Slow Net
244 Hydraulic Tank 1 low
245 Low air
251 E-Stop
255 Normal operation
Alarm List
All Faults and Alarms will show up on the Alarm List but only Check Enter Photo Eye will signal
an alarm on the screen and require an acknowledgement.
ACCEPT may need to be pressed from the POWERUP CHOICE screen if system is not
operating.
After and E-STOP or RESET, the Slow Comm Sta will change to 000. If a Station Number
appears, the comm. Cables to that station should be reviewed. If the station is not part of the
system, disable it at the HMI.
To Next Page
Loading...
