PL-6000DC/DCX Two-Post Parking Lift 23 P/N 5900273 — Rev. A6 —July 2024
Install the Top Cover Plate on each Post using four M10 x 30 Hex Bolts, Lock Washer, Flat
Washer, and Nut. Refer to figure below.
Drawing not to scale.
Insert the Threaded Rod with chain mount into the cover of the Offside Post and attach with
double M18 Nuts and Ø18 mm Flat Washer, then attach one end of the Balance Chain to the
Chain Mount using two split pins 2 x 20. See figure below. Allow the Balance Chain to hang from
its mount for the moment.
Note: There are two Chains provided with the Lift, a Balance Chain, and a Lift Chain. The
Balance Chain is the longer of the two.
Drawing not to scale.
⚠ CAUTION Keep Chains clean and away from dirt during installation.
To Next Page
Loading...
