H93: Parameter Initialize
Range: 0 - 5 (Default: 0)
Description: This parameter is used to initialize parameters back to the factory default
value. Each parameter group can be initialized separately or all parameters
can be initialized at once.
•
Select Enter () key after setting in H93. H93 will be displayed again
after initialization is complete.
H94: Password Register
Range: 0 - FFFF (Default:0)
Description: Password for H95-[Parameter lock]. Set as Hexa value (0-9, A, B, C, D, E,
F). Factory default password is 0. Enter the new password except 0.
•
Move to parameter H94 code.
•
Press Enter () key twice.
•
Register password. (Ex: 123).
•
Password will blink when Enter () key is pressed.
•
Press Enter () key.
109
6 - Parameter Descriptions
Do not forget the registered password. It is used when unlocking the
parameters.
CAUTION
Setting Range
Description
Selection Display
No 0
Displayed after initializing parameters.
All
Groups
1
All parameter groups are initialized to factory default value.
DRV 2
Only Drive group is initialized.
F1 3
Only Function group 1 is initialized.
F2 4
Only Function group 2 is initialized.
I/O
5
Only I/O group is initialized.
To Next Page
Loading...
Need help?
General
