H95: Parameter Lock
Range: 0 - FFFF (Default: 0)
Description: This function is used to lock the parameters from being changed. When the
parameters are locked, the display arrow changes from solid to dashed line
indicating that the parameters have been locked. This parameter is able to
lock or unlock parameters by typing the password registered in H94.
To lock the user-set parameter via the H94 [Password Register]:
To unlock the user-set parameter via password:
110
6 - Parameter Descriptions
Step Note Keypad Display
1 Move to H95 code. H94
2 Press Enter () key. L
3
Parameter value cannot be changed in L (Lock)
status.
L
4 Press Enter () key. 0
5 Enter the password created in H94 (e.g.: 123). 123
6 Press Enter () key. UL
7
Parameter value can be changed in UL (Unlock)
status.
UL
8 Press Enter () key. H95
Step Note Keypad Display
1 Move to H95 code. H94
2 Press Enter () key. UL
3
Parameter value can be changed in UL (Unlock)
status.
UL
4 Press Enter () key. 0
5 Enter the password created in H94 (e.g.: 123). 123
6 Press Enter () key. L
7
Parameter value cannot be changed in L (Lock)
status.
L
8 Press Enter () key. H95
To Next Page
Loading...
Need help?
General
