81
kWh Meter DRV 12
Run Time DRV 13
Power Time DRV 14
Output Freq DRV 15
DRV: kWh Meter
12 0.0 kWh
DRV: Run Time
13 1.6 h
DRV: Power Time
14 471 h
DRV: Output Freq
15 0.0 Hz
7 - PARAMETER DESCRIPTION
LCD Display
Description This display shows the power (KWh) consumed by the load
LCD Display
Description Total Run Time is a resettable timer for drive operation. To reset the timer, enter 10 in AFN 55 - Prog
Number on page 130.
LCD Display
Description Power Time displays how long the drive has been powered up.
LCD Display
Description The Output Frequency parameter shows the frequency being applied to the motor connected to the drive.
Drive Load DRV 16
DRV: Drive Load
16 +0.0%
LCD Display
Description The drive load parameter shows the percentage torque of the drive when operating below the knee
frequency. It displays Load Torque if the frequency is below nominal frequency and displays Power if
above Nominal Frequency. The output current is measured with the motor power factor applied to an
accuracy of ±20%. The parameter value is positive when the motor is pulling a load (“motoring mode”)
and negative when being pulled by a load (“regenerative mode”).
To Next Page
Loading...
Need help?
General
