BERGHOF DC1005 - Page 87

BERGHOF Automation Annex
2VF100055FE02.doc DC1000_HB_en_2D0982003ZD00.doc 87
1
Barcode
same as identification number.
2
Module type
plain-text name of module.
3
Identification no.
module's identification number
.
4
Model/order no.
You only need to give this number when ordering a module. The module will be
supplied in its current
hardware and software version.
5
Version
defines the design-level of the module as supplied ex-works.
6
Supply voltage
7
Date
internal code.
8
CE mark
The ‘Version’ (supply version) panel specifies the design-level of the mod-
ule as supplied ex-works.
When replacing a module, users, with the CNW (CANtrol Node Wizard) tool, can
read off the current software version of the newly supplied module, and then re-
load their 'own' software version for a particular project if necessary.
With the latter in mind, before the download you should always keep a record of
the existing software levels in your project documentation (software version, node
IDs, baud rate, etc.).