BERGHOF DC1005 - Product Description

BERGHOF Automation Product Description
2VF100107FE03.doc DC1000_HB_en_2D0982003ZD00.doc 15
2. Product Description
Short description The DIALOG CONTROLLER is a real-time control module with a display and a
broad spectrum of data interfaces. The module can be programmed in 'C' or in
accordance with IEC 61131-3 (CoDeSys 2.3).
Installation The DIALOG CONTROLLERs are intended for front panel or switch cabinet instal-
lation in harsh industrial environments. Maintenance is minimal, thanks to their fan-
free design and flash memory.
Processors The DIALOG CONTROLLER is equipped with either a 266 MHz or 400 MHz
POWERPC
TM
processor from Freescale.
Display The great differences in the appearance of the DIALOG CONTROLLER is based
on the selection of the employed display technology and a common display diago-
nal size. 5.7” units with a monochrome (STN), color (CSTN) or TFT display are a-
vailable. Above a diagonal screen size of 10.4” only TFT displays are employed.
Unit housing dimensions and protective method (IP65 on the front) do not depend
on whether the version in question has a touch screen or matrix keypad.
Ethernet A 10/100 MBit/s Ethernet interface is included. TCP/IP and UDP/IP protocols offer
highly flexible connections to visualization software, higher order control units or an
IT infrastructure.
USB ports The two USB host ports provide interfaces for widely dispersed peripheral devices.
For example, one USB stick can be used to quickly and easily perform application
updates or data extraction. Please contact our Technical Support if no driver sup-
port is available for a specific USB device.
CAN ports The DIALOG CONTROLLER is equipped with two standard CAN interfaces, both
of which can be operated at 1 MBit/s.
Serial ports A total of three serial ports can be used on the DIALOG CONTROLLER. The
RS232 programming interface is supplemented by an additional RS232 and an
RS485 port.