Attachment
114
11.3 Error messages
Message on the display Cause Repair
Stitch number unknown. > Check the entry and enter the new number.
Selection of the stitch pattern not
possible in the combi mode.
> Combine other stitches.
The feed dog is not lowered. > Push the button «Feed dog up/down» to lower the feed
dog.
The selected needle and stitch
plate cannot be used in
combination.
> Replace the needle.
> Replace the stitch plate.
The needle is not at its top end. > Adjust the needle position via the handwheel.
The main motor isn't running. > Turn the handwheel clockwise until the needle is at its
top position.
> Remove the stitch plate.
> Remove the thread remnants.
> Clean the hook.
> Remove the hook and make sure that there are no
pieces of broken neelde points on the magnetic back of
the hook.
Too less free capacity on the
BERNINA USB stick (optional
accessory).
Not enough free capacity on the
BERNINA USB stick (optional
accessory).
> Make sure that the BERNINA USB stick (optional
accessory) is used.
> Delete data from the BERNINA USB stick (optional
accessory).
No personal data on the
BERNINA USB stick (optional
accessory).
No personal data for recovery
available on the BERNINA USB
stick (optional accessory).
> Make sure that the data and settings have been saved
on the BERNINA USB stick (optional accessory).
The recovery of personal data has
failed.
The software update has been
successful but the personal data
couldn't be recovered.
> Make sure that the data and settings have been saved
on the BERNINA USB stick (optional accessory).
> Transfer saved data to the machine.
To Next Page
Loading...
