Bernina 435 - Changing the Presser Foot Sole; Changing the Presser Foot

Sewing preparation
36
Changing the presser foot sole
Removing the presser foot sole
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Push the button at the snap-on shaft.
– The presser foot sole is released.
Attaching the presser foot sole
> Place the presser foot sole beneath the shaft so that the cross pin is beneath the opening of the shaft.
> Lower the shaft via the lever.
– The presser foot sole snaps in.
Changing the presser foot
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Push the clamping lever up (1).