> Touch the icon «Update the machine».
> Touch the icon «Save data on USB Stick».
– The icon is checkmarked in green.
> Touch the icon «Update» to start the update of the firmware.
Recovering saved data
NOTICE
The BERNINA USB stick (optional accessory) has been removed too early
Saved data cannot be transferred and the machine cannot be used.
> Remove the BERNINA USB stick (optional accessory) only after the saved data has been transferred
successfully.
If personal data and settings after a software update are not available anymore, they can be transfered to
the machine again afterwards.
> Insert the BERNINA USB stick (Optional accessory) providing the saved data and settings into the USB port
of the machine.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Maintenance/Update».
> Touch the icon «Update the machine».
> Touch the icon «Transfer saved data to machine».
– The icon is checkmarked in green.
Lubricating the machine
CAUTION
Electronically driven components
Risk of injury near the needle and the hook.
> Switch the machine off and disconnect it from the power supply system.
NOTICE
Lubricating the hook
Too much oil can pollute the fabric and the thread.
> Always sew a test sample first.
To Next Page
Loading...
