> Touch the icon «Program the length with the stitch counter».
> Sew the desired buttonhole length.
> Stop the machine.
> Push the button «Quick reverse» so that the machine sews the lower bartack and the second bead in
reverse.
> Stop the machine at the height of the first stitch.
> Push the button «Quick Reverse» again so that the machine sews the upper bartack and the securing
stitches.
– The length of the buttonhole remains saved and every subsequent buttonhole is sewn identically until
the machine is switched off.
9.8 Determining the buttonhole length with the Buttonhole foot with
slide No. 3A
The button can be centered in the yellow circle on the display. By turning the «Upper/Lower
Multifunction knobs», the yellow circle can be enlarged or downsized to determine the diameter of the
button.
Additionally to the diameter of the button, 2 mm are added automatically for the buttonhole length. If the
diameter of the button is 14 mm, the buttonhole length is calculated 16 mm.
Prerequisite:
• The Buttonhole foot with slide No. 3A (optional accessory) is attached.
> Touch the icon «Buttonholes».
> Select the buttonhole.
> Touch the icon «i»-Dialog.
> Touch the icon «Adjust the buttonhole length».
> Turn the «Upper Multifunction knob» or the «Lower Multifunction knob» to adjust the buttonhole
length.
9.9 Sewing the manual 7-step buttonhole with the Buttonhole foot
No. 3
The length of the buttonhole is determined manually while sewing. Bartack, eye and securing stitches are
preprogrammed. The individual steps can also be selected by scrolling using the arrow icons or by touching
the button «Quick Reverse».
Prerequisite:
• The Buttonhole foot No. 3 is attached.
To Next Page
Loading...
