BFT CDS 1.3 - English

- 20 -
Contents
Page
1. INTRODUCTION 21
2. MAIN CHARACTERISTICS 21
3. TECHNICAL SPECIFICATIONS 22
3.1 CONTROL PANEL DIMENSIONS 22
4. INSTALLATION SAFETY 22
5. PRELIMINARY OPERATIONS 23
6. INPUT AND OUTPUT FUNCTIONALITY AND CONNECTIONS 23
6.1 J2 POWER TERMINAL BLOCK 23
6.2 J5 POWER TERMINAL BLOCK 23
6.3 J7 OUTPUTS/ACCESSORIES TERMINAL BLOCK 23
6.4 J9 INPUTS/OUTPUT TERMINAL BLOCK 24
6.5 J10 ELECTRIC BRAKE TERMINAL BOARD/ANTENNA 24
6.6 J13 PROGRAMMER CONNECTOR 24
7. PROGRAMMING 25
7.1 BASIC FUNCTIONS 25
7.2 1ST LEVEL PROGRAMMING 26
7.3 2ND LEVEL PROGRAMMING 27
7.4 3RD LEVEL PROGRAMMING 28
8. RADIO RECEIVER 29
8.1 RECEIVER TECHNICAL SPECIFICATIONS 29
8.2 RADIO CHANNEL FUNCTIONALITY 29
8.3 ANTENNA INSTALLATION 29
8.4 MANUAL PROGRAMMING 29
8.5 SELF-LEARNING MODE PROGRAMMING 30
9. CONNECTIONS FOR SIMULTANEOUS OPERATION 30
10. TROUBLESHOOTING GUIDE 30
11. ATTENTION 30
TABLE A 31
12. EXAMPLES OF CONTROLLING ENTRANCES 32
12.1 INSTALLATION A CONTROLLED ENTRANCE OR EXIT 32
12.2 INSTALLATION B AUTOMATIC ENTRY OR EXIT 33
12.3 INSTALLATION C CONTROLLED ENTRY AND EXIT 34
12.4 INSTALLATION D CONTROLLED ENTRY AND AUTOMATIC EXIT 35