BIFFI F01-2000 - Page 64

September 2021
Installation, Operation and Maintenance Manual
VCIOM-01249-EN Rev. 0
58
Set-Up Routines
Section 9: Set-Up Routines
The following situation can be congured individually to switch-over the monitor relay:
• motor over-temperature
• over-torque
• jammed valve
• LOCAL/OFF selected
• manual operation
• ESD signal on (ESD-EFS)
• low lithium battery (if present)
• LOCAL/STOP pressed
Auxiliary output relays
For status indication or diagnostic purposes, 8 voltage-free contacts of 8 relays are
available to be congured individually to switch for the following conditions:
Status
• open limit
• closed limit
• position >= xx %
• position <= xx %
• closing
• opening
• motor running
• blinker
• mid-travel position
• local selected
• remote selected
• local stop active
• ESD signal on
• manual operation
Alarm
• motor over-temperature
• over-torque
• over-torque in OP
• over-torque in CL
• valve jammed
• warnings
• valve jammed in OP
• valve jammed in CL
• low lithium battery (if present)
• mid travel alarm in CL/OP
• mains-only AS8