Installation, Operation and Maintenance Manual
MDE 254 Rev. 1 March 2021
HART Command Set 37
Section 8: HART Command Set
8.2.9 Command #108: Write Burst Mode Command Number
This command selects the response message that the device transmits while in Burst Mode.
Table 102. Request Data Bytes
Table 103. Response Data Bytes
Byte Format Description
0 Unsigned-8 Command Number of the response message to be transmitted
1 Unsigned-8 Burst Message
Byte Format Description
0 Unsigned-8 Command Number of the response message to be transmitted
1 Unsigned-8 Burst Message
Code Class Description
0 Success No Command-Specific Errors
1 Undefined
2 Error Invalid Selection
3 - 4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7 Error In Write Protect Mode
8 Warning Burst Condition Conflict
9 Error Invalid Burst Message
10 - 127 Undefined
No. Command Description
1 Read Primary Variable
2 Read Loop Current and Percent of Range
3 Read Dynamic Variables and Loop Current
9 Read Device Variables with status
48 Read Additional Device Status
Table 104. Command-Specific Response Codes
The following command can be represented in burst messages:
Table 105.
To Next Page
Loading...
