BIFFI ICON3000 - Burst Message Trigger Modes; Device Profile Codes

March 2021
Installation, Operation and Maintenance Manual
MDE 254 Rev. 1
HART Command Set44
Section 8: HART Command Set
Code Burst Message Trigger Mode Description
0
Continuous. The burst message is published continuously at (worst case) the
minimum update period.
1
Window. The burst message is triggered when the source value deviates more than
the specified trigger value.
2
Rising. The burst message is triggered when source value rises above the specified
trigger value.
3
Falling. The burst message is triggered when the source value falls below the specified
trigger value.
4 On-Change. The burst message is triggered when any value in the message changes.
Code Device Profile Code Description
1 HART Process Automation Device
2 HART Discrete Device
3 Hybrid: Process Automation + Discrete
4 I/O System
129 WirelessHART Process Automation Device
130 WirelessHART Discrete Device
131 WirelessHART Hybrid: Process Automation + Discrete
132 WirelessHART Gateway
141 WirelessHART Process Adapter
142 WirelessHART Discrete Adapter
144 WirelessHART-Enable Handheld / Portable Maintenance Tool
Table 133. Burst Message Trigger Modes
Table 134. Device Profile Code