KB (E4 + E6) 02/2017 page 111/148
18. Defrosting during refrigerating operation
BINDER cooling incubators are very diffusion-proof. To ensure high temperature precision there is no
automatic cyclic defrosting device. The DCT™ refrigerating system largely avoids icing of the evaporation
plates. However, at very low temperatures the moisture in the air can condense on the evaporator plates
leading to icing.
Always close the door properly.
• Operation with temperature set-points above +5 °C / 41 °F at an ambient temperature of 25 °C /
77 °F:
The air defrosts the ice cover automatically. Defrosting is continually performed.
• Operation with temperature set-points below +5 °C / 41 °F:
Icing on the evaporator is possible. Defrost the chamber manually.
With temperature set-points < +5 °C / 41 °F, regularly defrost the chamber manually:
• Set the temperature to 40 °C / 104 °F (in Fixed value entry mode)
• Let the chamber operate for about 30 minutes with the door closed.
Excessive frosting of the evaporator is indicated by reduced refrigerating performance.
• Operation with temperature set-points below 0 °C / 32 °F
While operating the KB with set-points below < 0 °C / 32°F condensation is possible at the inner sur-
face of the door around the door gasket.
In case of heavy condensation, check tightness of the door gasket.
After one or two days operation at a set-point < 0 °C / 32 °F a thin ice layer can cover the inner cham-
ber door and the glass door. The amount depends of the ambient temperature and humidity. This
does not influence the proper function of the refrigerating system.
Refrigerating performance decreases while operating the chamber at temperatures < 0 °C
/ 32 °F due to icing of the evaporators. For this reason defrost the chamber regularly, e.g.
once a week.
To Next Page
Loading...
