Binder KB 720 (E6) - Saving the Week Program and Leaving the Program Editor

KB (E4 + E6) 02/2017 page 75/148
10.3.8 Saving the week program and leaving the program editor
Fixed value
08.03.2015 05:05:06
Week program editor (example).
Press the “Menu” button.
..\ Temperature setpoint
[°C]
No.
Value
Day
H:M:S
Activity
1
35.00
Monday
08:00:00
Active
2
40.00
Monday
10:00:00
Active
3
35.00
Monday
18:00:00
Active
4
10.00
Monday
20:00:00
Active
5
35.00
Tuesday
08:00:00
Active
6
40.00
Tuesday
10:00:00
Active
7
35.00
Tuesday
18:00:00
Active
8
10.00
Tuesday
20:00:00
Active
Menu
Fixed value
08.03.2015 05:05:06
Submenu “Program menu”.
Select “Program save”
and press the operating button.
..\ Program menu
Select parameter
Save and exit
Save and run
Exit (without saving!)
Close
With the „Close“ button, The controller returns to the week program editor.
Select parameter Changing between temperature and fan speed.
Save and exit
Saving the program. The controller returns to the “Week programs”
submenu. You can now select and start the week program as de-
scribed in chap. 10.1.
Save and run
Saving the program and start it. Enter the start date and time, see
chap. 10.1. If another time or week program is running, the program is
only saved, but not started. A corresponding message is displayed.
Exit (without saving!)
Attention: the program is not saved. After a security question the con-
troller returns to the initial view.
Button „Close“ The controller returns to the week program editor. You can continue
programming.
Make sure that you saved the week program before leaving the program editor.