Binder KB 720 (E6) - Page 87

KB (E4 + E6) 02/2017 page 87/148
Fixed value
08.03.2015 05:05:06
Submenu “Network settings” (next page).
..\ Network settings
DNS 1
DNS 2
Close Home
Show network settings Overview of the entire network configuration
DHCP on/off Switching on and off the DHCP state
MAC address Display of the chamber’s MAC address
IP address Entering the desired IP address
Subnet mask Entering the subnet mask number
Chamber name Entering the name of the cooling incubator
Network name Entering the network name
Gateway Entering the gateway number
DNS 1 Entering the DNS 1 number
DNS 2 Entering the DNS 2 number
Set the DHCP State on/off:
Fixed value
22.08.2012 05:05:06
Submenu “DHCP On/Off”.
The current DHCP state is displayed. Press the op-
erating button to change it.
Then the new DHCP state is displayed
“DHCP : On” = DHCP state activated
“DHCP : Off” = DHCP state deactivated
..\ DHCP On/Off
DHCP : On
Close Home
Go back to the “Network settings” menu with “Close” or to the initial view with “Home”.
You can only configure the following network settings if the DHCP state is set to “Off”.