Handheld monitor user’s manual
Chapter 3-7
3.6.2 Spot-checking Mode
Spot-checking mode is intended for short-term on-site
measurement. This mode is normally selected to check
outpatient when doctors make rounds of the wards. The
patient ID will automatically increase from 1 to 99 according
to the connecting of SpO
2
sensor or ECG electrode. Details
are as follows:
Apply the SpO
2
sensor or ECG electrode to the patient.
After valid signals are detected,
1. The patient ID flashes and automatically increases
by 1 after 8 seconds to admit a new patient.
2. Press the Left button when the current patient ID is
flashing, the patient ID will stop flashing and remain
unchanged. The patient will not be admitted and new
measurements will be stored under the current patient
ID.
3. When the storage of patient measuring data reaches
its limit, the newly measuring data will cover for the
primary one.
To Next Page
Loading...