EasyManua.ls Logo

Biolight Meditech M800 - Monitoring Procedure; Skin Preparation

Default Icon
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Handheld monitor user’s manual
Chapter 6-3
Warning:
Do not use this device during defibrillation.
Interference from instruments near the patient and
ESU interference can cause problems with the ECG
wave.
The monitor cannot be directly applied to heart and
cannot be used for the measurement of endocardio
ECG.
During the measurement of ECG, when
interference from the mains causes distortion of the
ECG waveform, please disconnect the AC adapter
and use the battery to be the power supply.
6.3 Monitoring Procedure
6.3.1 Skin Preparation
Good electrode-to-skin contact is important for a good
ECG signal, as the skin is a poor conductor of electricity. It
is necessary to deal with the skin properly before placing the
electrodes. The steps are shown as follows:

Table of Contents