Handheld monitor user’s manual
Chapter 6-4
1. Select sites with intact skin, without impairment of any
kind.
2. Clip or shave hair from sites as necessary.
3. Gently abrade the skin to remove dead skin cells to
improve the conductivity of the electrode site.
4. Wash sites thoroughly with soap and water, leaving no
soap residue.
(We do not recommend using ether or pure alcohol, because
this dries the skin and increases the resistance.)
5. Dry skin thoroughly.
6.3.2 Placing Electrode
1.
Preparation before placement
1) Skin preparation (refers to Chapter 6.3.1);
2) Check if the buttons on the electrodes are clean and free
of damage;
3) Place the electrodes on the body of patient. Before
attaching, smear some conducting cream on the electrodes if
the electrodes are not electrolyte self-supplied;
4) Connect the cable leads to the electrodes through the
buttons of the electrodes.
To Next Page
Loading...