Handheld monitor user’s manual
Chapter 5-4
5.3 Monitoring Procedure
1. Selecting SpO
2
Sensor
Depending on the patient category, weight and
application site, you can select the SpO
2
sensor as required.
2. Connecting SpO
2
Sensor
Plug the SpO
2
sensor cable into the SpO
2
connector on
the measurement module.
3. Applying SpO
2
Sensor
Clean the application site, such as colored nail polish,
and apply the sensor to the patient.
Warning:
Do not use the SpO
2
sensor on a limb where the
NIBP cuff is applied. This may result in inaccurate
SpO
2
reading due to blocked blood flow during cuff
inflation.
Do not conduct SpO
2
measurement on the finger
smeared with nail polish, otherwise unreliable
measurement results might be produced.
When using finger sensor, make sure the nail faces
to the light window.
To Next Page
Loading...