Handheld monitor user’s manual
Chapter 4-9
The factory configuration is loaded;
Set the alarm volume to a nonzero value.
When a factory configuration is selected, the alarm
volume of the monitor may be lower than the minimum
alarm volume. In this case the alarm volume is automatically
adjusted according to the minimum alarm volume.
Warning:
When the alarm sound is switched off, the monitor
will give no audible alarm tones even if a new
alarm occurs. Therefore the user should be very
carefully about weather to switch off the alarm
sound or not.
Don’t rely exclusively on the audible alarm system
for patient monitoring. Adjusting alarm volume to
a low level may result in a hazard to the patient.
Always keep the patient under close surveillance.
To Next Page
Loading...