N-15Rev F
InStallatIon
N-15
prInt mode
This setting will determine if the meter prints automatically or only when requested.
1. From a list of programmable parameters, choose meter SettIngS
using the
keys.
2. Press the key.
3. Use the
keys to select
dISplay SettIngS.
4. Press the key.
5. Use the
keys to select highlight the word to the right of prInt mode.
6. Use the
keys to choose automatIc or manual. If automatIc is selected,
the meter will immediately print out the results after each test (patient, QC, Misc.
Test). If manual is selected, the user must use the button on the keypad to
print out results.
7. Press the key to save changes.
maIn menu
Set parameterS
meter SettIngS
dISplay SettIngS
To Next Page
Loading...
