Biosite Triage MeterPro - Page 26

N-16 Rev F
Run Test
InStallatIon
N-16
auto power – oFF
This setting will determine the length of time before an inactive meter will power off.
1. From a list of programmable parameters, choose meter SettIngS
using the keys.
2. Press the key.
3. Use the keys to select dISplay SettIngS.
4. Press the key.
5. Use the keys to select the value to the right of auto power-oFF.
6. Use the keys to choose the desired timer setting for the meter to power
itself off when not in use. The choices are:
1
/2 hour, 1 hour, 2 hourS, 4 hourS or
none. If none is selected, the meter must be manually shut off using the on/off
key.
7. Press the key to save changes.
dISplay contraSt
This setting will adjust the display contrast.
1. From a list of programmable parameters, choose meter SettIngS
using the keys.
2. Press the key.
3. Use the keys to select dISplay SettIngS.
4. Press the key.
5. Use the keys to select the number to the right of contraSt.
6. Use the keys to change the contrast of the meter’s screen.
The range is from 0 – 8 (8 being the greatest contrast).
7. Press the key to save changes.
maIn menu
Set parameterS
meter SettIngS
dISplay SettIngS
Note: When
powered only
by batteries, select
1
/2 hour to conserve
battery life.
Certain screens, when
displayed, will not
automatically power
off.TheNewResults
screenisanexample.