Biosite Triage MeterPro - Page 30

N-20 Rev F
InStallatIon
N-20
lIS enaBle
1. From a list of programmable parameters, choose meter SettIngS
using the keys.
2. Press the key.
3. Use the keys to select comm SettIngS
4. Press the key.
5. Use the keys to select lIS.
6. Use the keys to choose dISaBled or enaBled.
7. Press the key.
8. If dISaBled was selected, a screen showing lIS dISaBled will appear. Press
the key.
9. If enaBled was selected, a screen showing enter lIS paSSword will appear. Enter
the password provided by Biosite Technical Services. Press the key.
10. Acknowledge the lIS enaBled message by pressing the key.
auto upload (This feature is visible after the LIS has been enabled.)
1. From a list of programmable parameters, choose meter SettIngS
using the keys.
2. Press the key.
3. Use the keys to select comm SettIngS.
4. Press the key.
5. Use the keys to select auto upload.
6. Use the keys to choose enaBled or dISaBled.
7. Press the key.
maIn menu
Set parameterS
meter SettIngS
comm SettIngS