M-8Rev F
care & maIntenance
Cleaning
The Triage MeterPro Meter requires minimal maintenance. Occasional cleaning of the
exterior with mild soap and water solution is sufficient. After using a damp, not wet,
sponge or cloth to apply a mild soap and water solution on the outside of the meter,
wipe the meter dry using a soft cloth or
absorbent tissue. Do not allow water to seep
into the printer. Do not immerse the meter in
water or other liquids.
If blood or other fluids are not allowed enough
time to fully absorb into test devices, the
device track door may occasionally require
cleaning. Using a cotton swab dampened
with isopropyl alcohol and a pair of tweezers,
carefully lift the door and clean both front and
back of the door.
Check Battery Level
The Triage MeterPro Meter checks the active power source after ejecting a device
or printing. To check the battery power, navigate to the Main Menu, disconnect the
AC power supply, press the key (the meter attempts to eject the device), and
look for the Low Power Indicator on the Main Menu of the meter display. If the flashing
indicator appears, replace the batteries.
Battery Replacement
• Turnoffthemeter.
• Removethebatterycoverfromthebottomofthemeterbyslidingthecoverinthe
direction of the arrow.
• Removethebatteriesanddiscardtheminanappropriatewastecontainer.
• InsertfoursizeAA1.5voltbatteriesintothe
battery compartment. Be sure that the plus (+) and
minus (-) signs of the batteries match the same signs
embossed in the battery compartment.
• Replacethecovertothebatterycompartment.
Note: If the
meter does not
power on after
replacing batteries,
verify the batteries are
lined up according to
the symbols in the
battery compartment.
Note:
Rechargeable
batteries are
authorized for use,
however, due to the
nature of these types
of batteries, it is
expectedtheywill
require recharging
more frequently. The
Triage MeterPro Meter
does not contain a
built-in battery
charger, rechargeable
batteries must be
recharged outside of
the meter.
To Next Page
Loading...
