If green light indicator on Faros device does not blink when device is connected to your computer with
Bittium SafePort USB cradle, there may be a connection issue. In this case, you should first check that the
Faros device is properly attached to Bittium SafePort USB cradle. If this is not the case, then disconnect the
USB cable connection and reconnect again, also check carefully that the USB connection between the
device and the cable and between the cable and your computer is not loose.
4.6.2 Recharging the battery with the Bittium SafePort
Connect Faros device to computer with Bittium SafePort as described in chapter 4.6.1.
Blue light indicator in Faros device starts to blink when the device is recharging.
Blue light indicator is lit when the battery of Faros device is fully charged.
4.7 Troubleshooting
If the device does not work or operation is unpredictable, try the following:
Recharge the device
• Follow instructions in chapter 4.4.
Device does not start measurement (error light indicator blinks three (3) times)
• Recharge the device.
• Synchronize the device clock via Faros Manager.
• Save settings.
Reset the device
• Push the pushbutton until all light indicators flash.
• Power on the device by pushing the power button.
To Next Page
Loading...