Installation Operating instructions SC II
22 / 107 61429850113 en-US
Installation of power supply provided by customer
The installation of the power supply for connecting to our equipment must be carried out in
accordance with the international specifications and the regulations derived from them.
These essentially include the recommendations of at least one of the following commissions:
– International Electro-technical Commission (IEC)
– European Committee for Electro-technical Standardization (CENELEC)
– German Association for Electrical, Electronic and Information Technologies (VDE)
Check before connecting to mains!
– Before connecting the device, check
– mains data on identification plate.
– mains data of the mains supply.
WARNING
– Incorrect supply voltage!
– Do not connect device to mains supply if mains data does not
match the connection values of the scale. Mains data must be
identical.
– Inform Bizerba Customer Service.
4.5.4 Cable connections
CAUTION
Do not insert or remove connecting cable while device is
switched on!
Interfaces are either defect or malfunctioning.
– Always switch device off before inserting or removing the con-
necting cable.
Secure power cable from falling out by means of strain relief.
To Next Page
Loading...
Need help?
General
