27
• Press “CH1”→“BW Limit”→ “On”, and bandwidth will be
limited to 20 MHz.
• Press “CH1”→“BW Limit”→ “Off”, and bandwidth limit
will be disabled.
Figure 3.9 – Bandwidth Limit
3. Volts/Div Settings
Vertical scale adjust have Coarse and Fine modes, Vertical
sensitivity range of 2 mV/div – 10 V/div.
Take CH1 for example:
• Press “CH1”→“Volts/Div”→“Coarse”. It is the default
setting of Volts/Div, and makes the vertical scaling in a 1-
2-5-step sequence from 2 mV/div, 5 mV/div, 10 mV/div
to 10 V/div.
• Press “CH1”→ Volts/Div”→ Fine”. This setting changes
the vertical control to small steps between the coarse
settings. It will be helpful when you need to adjust the
waveform vertical size in smaller steps.
To Next Page
Loading...
