14 Record
Press the record button to begin recording immediately. Press again to stop recording.
15 Still
Use the ‘still’ button to capture a single Blackmagic RAW frame when your camera is in
standby, record or playback mode. A camera icon appears briefly in the top right corner of
the touchscreen display to let you know you have successfully captured a still.
Image files are saved to the ‘stills’ folder in the root directory of the media you are currently
recording to. Stills follow the file naming convention for video clips except the filename
includes the still number in the last four characters of the filename.
16 ISO
Press the ISO button and then rotate the settings wheel to adjust your camera’s ISOsetting.
ISO can be set at 1/3 stop increments between 100 and 25,600.
17 Shutter
To change the shutter angle or shutter speed, press the shutter button, then rotate
the settings wheel. The touchscreen display will also suggest up to three flicker free
shutter options.
18 White Balance
Press the white balance button and then rotate the settings wheel to adjust your camera’s
white balance. You can also quickly enter the ‘auto white balance’ screen byholding the
‘wb’ button for 3 seconds. Your camera will overlay a white square in thecenter of your
image, and use this area to perform an auto white balance. For more information refer to
the ‘touchscreen controls’ section.
19 Viewfinder Connector Port
Blackmagic Cinema Camera 6K has a connector port for Blackmagic Pocket Cinema
Camera Pro EVF. If the optional electronic viewfinder is not installed, you can attach the
supplied protective cover.
20 Power Switch
Power switch for turning on the camera. Slide the switch to the right to power on your
camera, and to the left to power off.
21 Status LED
When the camera is turned off and plugged into external power via the 12V DC power
jack or USB-C port, the indicator illuminates red to indicate the battery is being charged.
The status LED turns off when the battery is fully charged.
22 Function Buttons
These buttons can be programmed to a variety of commonly used functions using your
camera’s ‘setup’ menu. By default, button one is set to ‘false color’, button 2 is set to
‘display LUT’ and button 3 is set to ‘frame guides’.
The last sentence /
paragraph deleted
26Camera Features
To Next Page
Loading...
