SAM 950 Berkeley Nucleonics Corporation 14 of 62
SAM 950 SOFTWARE
SAM 950 software consists of two programs.
1. “SAM III PeakAbount II”: application software for the PDA
2. “SAM III PeakID”: command center software for a PC running the Windows Operating system.
The PDA application software is preinstalled in the imbedded PDA.
The PDA application SW is used in the configuration and calibration procedures as well as for the real-time
measurement and analysis of spectral data acquired by the SAM 950.
The command center software supports event-log file management, integration of data from multiple units,
and data backup.
For detailed installation instructions please refer to the appropriate sections in this manual.
Command center software is compatible with Windows based PCs. The OS must be Windows 7 or
higher.
PREREQUISITES FOR THE OPERATION OF THE SAM 950
✓ Charge the SAM 950 battery
1. Turn off the system (recommended for fastest time to full charge)
2. Plug-in the DC adaptor to the DC connector
3. The LED on the DC power adaptor changes to green when the unit is charging.
4. Full charge may take up to 6 hours.
5. The LED on the DC power adaptor OFF when the unit is fully charged.
6. The charging cable is securely locked to the female connector on the unit. Disengage the spring
loaded connector by firmly holding the male connector and gently twisting ¼ turn, then pulling
straight back on the connector.
For detailed setup, configuration, background measurement and calibration procedures please refer to
the appropriate sections in this manual.
To Next Page
Loading...