Functions and operation
EN
www.bora.com 27
Fig.5.23
Resetting the filter service display
T
The filter service life is reset and the filter service display is
deactivated.
T
is shown in the control knob displayed.
5.5
Operating the cooktops
The full range of functions is only available for Professional
3.0 system cooktops in combination with the cooktop
extractors.
Clean the cooking zone before using the cooktop for the first
time (see"7Cleaning and maintenance").
5.5.1
General operating instructions for
cooktops
Cooktops are operated with 2 control knobs. There are 9 power
levels, an optional power setting and various functions available for
each cooking zone. Each cooking zone has its own control knob; the
front cooking zone is operated using the left-hand knob and the rear
cooking zone using the right-hand knob.
Fig.5.24
Cooking zone indicator
[1]
active front cooking zone
[2]
active rear cooking zone
Restricted functions when using the cooktops without a
cooktop extractor
If cooktops are installed and operated without a cooktop extractor,
only limited functions will be available. The following functions will not
be available:
T
System functions
T
Pause function
T
Short-time timer
T
Child lock
T
All settings/functions in the configuration menu
5.5.2
Special operating instructions for
the Tepan stainless steel grill
Initial operation:
u
Heat the griddle to 220°C for approx. 25 minutes before using it
for the first time (= power level 8 for both grilling zones).
T
Bothersome odours may be emitted during this process.
Operating instructions:
u
Clean the grill surface before using the appliance for the first time
(see"7Cleaning and maintenance").
u
Preheat the grilling zone for 5 minutes before it is used each time.
T
During heating or cooling the griddle may make some noise. This is
a normal occurrence.
T
A fan is built in to the Tepan stainless steel grill for cooling,
guaranteeing a long service life for the electronic components and
rapid cooling of the grill surface. Different measures have been
taken to keep noise to a minimum, but it cannot be completely
avoided.
T
During use, the griddle may show signs of curvature.
T
During grilling or heating on a high power level, the griddle may
adopt a light brown colour.
5.5.3
Special operating instructions for
the gas cooktop
When operating the cooktop for the first time or after a
prolonged period without use or when the liquid gas bottles
have been changed, it is possible that the burner may not
ignite. This may be due to air in the gas pipe or the electronic
gas regulator may need recalibrating. Follow the initial
operation instructions (see “Installation instructions”).
In the case of the gas cooktop, due to the use of enamelled
cast iron parts, slight colour variations and irregularities are
common. Furthermore, flash rust may appear at the support
points, which can be easily removed with a damp cloth. These
spots are normal and are not considered an impairment.
As a result of use, some of the components of the gas
cooktop can become discoloured. This discolouration is
normal and does not have a negative effect on the gas flame
or the functioning of the cooktop.
When using the gas burner, you may hear gas escaping from
it. The burner flame turns orange as a result of prolonged
operation and/or impurities on the burner and in the ambient
air (dust). These properties are normal and can occur
independently of one another.
In the event of smoke or fire while operating the gas cooktop,
turn off the gas supply and switch off the appliance at the wall
socket.
If you smell gas or have problems with the gas installation,
switch off the gas supply. Open the window and ensure good
ventilation.
To Next Page
Loading...
Need help?
General