Functions and operation
EN
www.bora.com 29
T
As soon as the target temperature is reached, the warm-up phase
comes to an end and the target temperature is continuously
displayed.
5.5.5
Cooktop power setting
When the power setting is activated, maximum cooking zone power is
available for a predefined time. The available power is targeted at the
cooking zone, meaning that the max. power of the second cooking
zone is automatically reduced temporarily.
Activating the power setting for a cooking zone
u
Turn the knob ring clockwise to power setting P.
T
After 10 minutes, the power setting is automatically switched back
to power level 9 (20 minutes on the gas cooktop).
T
The power setting cannot be activated if the bridging function is
switched on
T
If one cooking zone is operated on the power setting, the second
cooking zone can be operated at a maximum power level of 5.
T
On the cooktop PKCH3 the power setting corresponds to the
Hyper setting.
Never heat up oil, fat and the like on the power setting. The
bottom of the pan can overheat due to the high power output.
Activating the power setting on the Tepan stainless steel
grill
u
Turn the knob ring clockwise to temperature 240/250°C (= power
setting).
T
After 10 minutes, the power setting is automatically switched back
to power level 9 (230°C).
T
On the Tepan stainless steel grill, both cooking zones can be
operated on the power setting at the same time, even with the
bridging function.
Deactivating the power setting
the power setting is deactivated early if another power level is set.
5.5.6
Bridging function
With the bridging function two cooking zones can be combined to
form one large cooking zone. The power for the combined zones is
then adjusted by a single operating control. Power adjustment takes
place simultaneously (both cooking zones are operated on the same
power level). The bridging function is suitable for heating food, e.g. in
a roaster.
If both cooking zones are already in use when the bridging function is
activated, the lower of the two power levels will be adopted for both
cooking zones.
If a timer is running when the bridging function is activated, this is
adopted. If 2 timers are running, the shorter one is used for the
bridging function.
Activating the bridging function
u
Touch command on both control knobs at the same time.
T
An acoustic signal can be heard and the bridging function is
activated.
T
The power level and both cooking zone indicators are shown on
both control knobs.
Fig.5.26
Activating the bridging function
Deactivating the bridging function
u
Set the power level to 0.
or
u
Touch command on both control knobs at the same time.
T
An acoustic signal can be heard and the bridging function is
deactivated.
T
The current power levels are retained.
T
Each cooking zone then goes back to being operated separately.
5.5.7
Pause function
With the pause function all cooking zones can be quickly and easily
deactivated temporarily. When the function is cancelled, operation
resumes at the original settings. The cooking session can be paused
for a maximum of 10 minutes. Once 10 minutes have lapsed, the
cooking session is automatically ended.
During the pause, fan function is not interrupted. Active
bridging and short-time timer functions remain active. Active
cooking zone timers are stopped.
Activating the pause function
u
Double tap the cooktop extractor control knob
T
appears in the cooktop extractor control knob display fading in
and out.
T
The cooktop control knob displays are dimmed.
To Next Page
Loading...
Need help?
General