Functions and operation
EN
www.bora.com 33
5.6.5
Automatic heat up function
When the automatic heat up function is activated, the cooking zone
works at full power for a certain time and is then automatically reset
to the previously set level.
Power level (continuous cooking
level)
Cooking times in min:sec
00:40
1:00
2:00
3:00
4:20
7:00
2:00
3:00
Tab.5.11
Overview of induction and gas cooktop heating times
Power level (continuous cooking
level)
Cooking times in min:sec
1:00
3:00
4:48
6:30
8:30
2:30
3:30
4:30
Tab.5.12
Overview of Hyper and HiLight cooktop heating times
If the cooking zone power level is increased while the
automatic heat up function is active, the automatic heat up
function remains active. The heating time is adjusted
accordingly.
If the cooking zone power level is decreased while the
automatic heat up function is active, the automatic heat up
function is deactivated.
Activating the automatic heat up function
Fig.5.39
Activating the automatic heat up function
T
An acoustic signal is heard, the automatic heat up function is
activated and the corresponding timer counts down.
T
The control knob display shows the heat-up symbol and the set
power level (e.g. ).
Deactivating the automatic heat up function early
u
The activated automatic heat up function will end prematurely if
you
u
reduce the power level (continuous cooking level);
u
set the power level;
u
the power setting the power setting;
u
activate the power setting;
u
switch off the cooktop.
Time lapsed
T
When the heat up time has lapsed, the previously set continuous
cooking level will be activated.
T
An acoustic signal is heard.
T
The heat-up symbol will no longer be displayed.
5.6.6
Cleaning function
The cleaning function adjusts the Tepan stainless steel grill to a
constant temperature of 70°C, which is perfect for cleaning. This
temperature is then maintained for 10 minutes.
Activating the cleaning function
Fig.5.40
Activating the cleaning function
T
The cleaning function is activated and the Tepan stainless steel grill
is heated to 70°C.
T
Both control knobs show and both cooking zone indicators flash
during the warm-up phase.
T
As soon as the cleaning temperature is reached, the cooking zone
indicators are permanently lit and it is possible to start cleaning.
Deactivating the cleaning function
u
Turn a knob ring anticlockwise.
T
The cleaning function is deactivated.
When the knob ring is turned clockwise, a higher power level
is activated and cleaning must be stopped immediately (risk
of burns).
To Next Page
Loading...
Need help?
General