Cleaning and maintenance
EN
www.bora.com 41
7.2.2
Fitting the cover flap, grease filter
and filter tray
u
Insert the filter tray in the opening on the extractor.
u
Insert the grease filter into the opening in the extractor.
u
Ensure that the grease filter sits correctly in the gap in the housing.
u
Lay the cover flap on its side next to the extractor opening.
u
Allow the cover flap to slide diagonally into the holder.
u
Press the ends of the cover flap lightly from above until you hear
them click into place.
u
Make sure that the cover flap has been fitted correctly.
T
If the cover flap is not properly installed in its locking mechanism,
it will not close fully.
T
If the grease filter or cover flap has not been properly fitted, the
error message ‘E012’, ‘E013’ or ‘FF out’ appears on the control
knob’s display (see"8Troubleshooting").
Fig.7.2
Fitting the components
Fig.7.3
Fitting the cover flap
[1]
Extractor opening
[2]
Holder
[3]
Cover flap
7.2.3
Removing the maintenance tray
The maintenance tray cannot be removed in the following installation
situations:
T
single installation
T
second adjacent extractor
T
adjacent wok cooktop
To remove the maintenance tray, the grease filter and filter tray must
be removed first.
u
Turn the two levers of the lock outwards 90° to unlock the
maintenance tray.
u
Lift the maintenance tray out of the cooktop extractor.
Fig.7.4
Removing the maintenance tray
[1]
Maintenance tray
[2]
Lock
7.2.4
Installing the maintenance tray
u
Slide the maintenance tray into the cooktop extractor.
u
Turn the two levers of the lock downwards to lock the maintenance
tray.
Fig.7.5
Installing the maintenance tray
7.2.5
Cleaning the components
The cover flap, grease filter, filter tray and maintenance tray can be
cleaned by hand or in the dishwasher.
To Next Page
Loading...