Bosch APC-AMC2-4R4CF User Manual (English)

Other manuals for Bosch APC-AMC2-4R4CF

Questions and Answers:

D
Devin PattersonAug 7, 2025
What to do if Bosch IP Access Controller does not work as expected?
- J
  Jeanette IbarraAug 7, 2025
  If your Bosch IP Access Controller isn't working as expected, try these steps: First, switch the power of the controller off and on again. If the problem persists, check the configuration of the controller and if necessary, delete all configuration data by resetting the device to factory default. As a last resort, reset the controller as described in Resetting the software.
C
craigpittsAug 13, 2025
Why is my Bosch IP Access Controller not online?
- L
  Lisa RobinsonAug 13, 2025
  Your Bosch IP Access Controller might not be online due to a missing network connection. Ensure the Ethernet cable is securely plugged into the controller. Also, check the DIP switch 5 setting. If it's set to OFF (BPA protocol), set it to ON (SDEB protocol).
A
Ann SellersAug 18, 2025
How to fix Bosch IP Access Controllers display if it is not working?
- M
  moyeremilyAug 18, 2025
  If the display on your Bosch IP Access Controller isn't working, it could be due to low voltage. Make sure the power supply provides enough voltage to power the controller. Also, check that the power is on.
C
Christie MoralesAug 25, 2025
What to do if there is no connection to BIS and AMS after a factory reset on Bosch IP Access Controllers?
- A
  Arthur VillarrealAug 26, 2025
  If you have no connection to BIS and AMS after a factory reset on your Bosch IP Access Controllers, verify the controller is activated in the configuration settings.
D
Deborah PerezAug 31, 2025
Why is there no connection to BIS and AMS after factory reset of Bosch IP Access Controllers?
- K
  kcruzAug 31, 2025
  If there is no connection to BIS and AMS after a factory reset of your Bosch IP Access Controllers, it might be due to a connection issue with the access system. Check the configuration settings within the AMS or ACE system.