Bosch APC-AMC2-4R4CF - Resetting the Device to Factory Default

96 en | Operating Access Modular Controller 2
2020-01 | V02 | Installation manual Bosch Access Systems V.B.
5.3.2 Resetting the Device to Factory Default
1. Reset the AMC2-4R4 as described above.
2. Open the upper case of the AMC2-4R4 as described in Opening the Case, page 36.
3. Set all six DIL switches of the RS-485 selector to ON as shown in the figure below.
4. Press the reset button on the the board.
5. Set the DIL switches back in the address state before resetting.
1. Reset the AMC2-4W as described above.
2. Open the upper case of the AMC2-4W as described in Opening the Case, page 36.
3. Set all six DIL switches of the RS-485 selector to ON as shown in the figure below.
4. Press the reset button on the the board.
5. Set the DIL switches back in the address state before resetting.
The AMC2-4R4 now has the following network configuration:
– DHCP = 1
– IP = [assigned by DHCP server or “0.0.0.0” if not available]
– Subnet mask = [assigned by DHCP server or “0.0.0.0” if not available]
– Password = no password
The AMC2-4W now has the following network configuration:
– DHCP = 1
– IP = [assigned by DHCP server or “0.0.0.0” if not available]
– Subnet mask = [assigned by DHCP server or “0.0.0.0” if not available]
– Password = no password
Figure5.7: Resetting the AMC2 to delivery state
Figure5.8: Resetting the AMC2-DCUA to delivery state