Bosch APC-AMC2-4R4CF - Wiegand Interface for Card Readers

Access Modular Controller 2 Installing | en 69
Bosch Access Systems V.B. Installation manual 2020-01 | V02 |
4.13 Wiegand Interface for Card Readers
Notice!
If your reader requires a voltage other than 12V or is the power consumption more than 200
mA then it will require an external power supply.
The AMC2-4W provides four ports for connecting a maximum of 4 readers with Wiegand
interfaces. Each interface is connected using a 10-pin pluggable screw - refer to Connecting
Diagrams, page 102 .
Figure4.54: Location of the Wiegand interfaces for external devices
Figure4.55: Location of the Wiegand interfaces for external devices