Bosch APC-AMC2-4R4CF - 4.14 Tamper protection

Access Modular Controller 2 Installing | en 33
Bosch Access Systems V.B. Installation manual 2020-01 | V02 |
4 Installing
Notice!
To build an UL approved system refer the documentation contained in the folder titled "_UL"
on the delivered CD.
Notice!
To build a UL listed configuration, refer to UL Requirements
4.1 Mounting
The AMC2-4R4 can be attached on a standard 35mm (1.377in.) mounting rail using a snap-in
mechanism. Attach the AMC2-4R4 into the upper edge of the mounting rail [1], then push
down the device and snap it onto the rail by pushing it towards the back [2].
The AMC2-4W can be attached on a standard 35mm (1.377in.) mounting rail using a snap-in
mechanism. Attach the AMC2-4W into the upper edge of the mounting rail [1], then push
down the device and snap it onto the rail by pushing it towards the back [2].
Figure4.1: Mounting the AMC2 on a mounting rail
Figure4.2: Mounting the AMC2 device on a mounting rail