Bosch APC-AMC2-4R4CF - Tamper Protection

Access Modular Controller 2 Installing | en 87
Bosch Access Systems V.B. Installation manual 2020-01 | V02 |
4.18 Tamper Protection
To protect the AMC2-4R4 against unauthorized access and so prevent tampering with
sensitive data, the AMC2-4R4 provides an additional interface to connect external tamper
contacts. This interface is a potential-free 2-pin pluggable screw connector marked with T.
When not in use this tamper contact should be shorted.
To protect the AMC2-4W against unauthorized access and so prevent tampering with sensitive
data, the AMC2-4W provides an additional interface to connect external tamper contacts. This
interface is a potential-free 2-pin pluggable screw connector marked with T. When not in use
this tamper contact should be shorted.
Figure4.81: Location of the tamper protection contact
Figure4.82: Location of the tamper protection contact