Bosch APC-AMC2-4R4CF - 5 Operating; 5.1 Configuring Ethernet interface

34 en | Installing Access Modular Controller 2
2020-01 | V02 | Installation manual Bosch Access Systems V.B.
4.2 Unmounting
Notice!
To remove the AMC2-4R4 from a mounting rail, first remove all pluggable connectors.
Push down the AMC2-4R4 until the lower edge snaps out of the mounting rail [1]. Pull the
lower end of the AMC2-4R4 from the mounting rail [2].
Notice!
To remove the AMC2-4W from a mounting rail, first remove all pluggable connectors.
Push down the AMC2-4W until the lower edge snaps out of the mounting rail [1]. Pull the
lower end of the AMC2-4W from the mounting rail [2].
Figure4.3: Unmounting the AMC2 from a mounting rail