Access Modular Controller 2 Installing | en 61
Bosch Access Systems V.B. Installation manual 2020-01 | V02 |
4.11 DIL switch selector
DIL switches are used to configure the host settings. The first four DIL switches for address
selection. Switch 5 selects one of the two different protocols, SDEB and BPA (according to
DIN6619).
Notice!
If using an Ethernet connection, set switch 1 to ON (= factory setting).
Figure4.44: Location of the selector for host settings
Address
DIL Switches
1 2 3 4
none OFF OFF OFF OFF
1 ON OFF OFF OFF
2 OFF ON OFF OFF
3 ON ON OFF OFF
4 OFF OFF ON OFF
5 ON OFF ON OFF
6 OFF ON ON OFF
7 ON ON ON OFF
8 OFF OFF OFF ON
Tab.4.4: Setting the address via the DIL switch
Mode
DIL Switches
5 6
ON SDEB RS-232
OFF BPA RS-485
Tab.4.5: Protocol and connection settings
To Next Page
Loading...
