Bosch APC-AMC2-4R4CF - 4.4 Closing the case

16 en | Introduction Access Modular Controller 2
2020-01 | V02 | Installation manual Bosch Access Systems V.B.
3.1.3 Extension AMC2-16IE
Another variant of the extension modul AMC2-16IOE is the AMC2-16IE which offers connectors
for input signals only.
The inputs are located at the same positions as on the AMC2-16IOE. The output connections
in the AMC2-16IE are not usable. Within a system configuration the AMC2-16IE is treated as a
normal extension module:
It can be connected at any AMC2. Up to three extensions (for BIS three, for Access PE only
one) can be connected to an AMC2. Extension variants can be used in any combination.
Figure3.13: Extension module AMC2-16IE
Notice!
The AMC2-16IE is identical in all respects to the AMC2-16IOE except in missing outputs.
Information in this manual refers to all three extensions described here, unless explicitly
stated otherwise.
3.2 Equipment Configuration
Figure3.14: Upper circuit board with display (top side)