Bosch APC-AMC2-4R4CF - Table of Contents

Access Modular Controller 2 Table of contents | en 3
Bosch Access Systems V.B. Installation manual 2020-01 | V02 |
Table of contents
1
Safety Instructions 5
1.1 Important safety notes 5
1.2 Safety precautions 6
1.3 Unpacking 7
2
Important Information 8
2.1 Explanation of symbols in this document 8
2.2 Internet 8
3
Introduction 9
3.1 Description 9
3.1.1 Extension AMC2-16IOE 14
3.1.2 Extension AMC2-8IOE 15
3.1.3 Extension AMC2-16IE 16
3.2 Equipment Configuration 16
3.3 Performance Characteristics 26
3.4 System Overview 27
4
Installing 33
4.1 Mounting 33
4.2 Unmounting 34
4.3 Opening the Case 36
4.4 Closing the Case 39
4.5 Cabling 40
4.5.1 Conductor data for power to AMC2 40
4.6 Grounding and Shielding 42
4.6.1 Grounding for Host Interface 43
4.6.2 Grounding for Extension Interface 44
4.6.3 Grounding for Bus Interfaces 45
4.7 Connecting Power Supply 46
4.7.1 Direct Power Supply 47
4.7.2 Power Supply via RS-485 Interface 48
4.7.3 Overview - Power supply/consumption 49
4.8 Ethernet Host Interface 53
4.9 RS-485 Host Interface 55
4.9.1 RS-485 Two Wire Connection 57
4.9.2 RS-485 Four Wire Connection 58
4.10 RS-232 Host Interface 60
4.11 DIL switch selector 61
4.11.1 Host settings 62
4.11.2 Setting the host 63
4.11.3 Board Settings 64
4.12 RS-485 for extension modules 65
4.12.1 Addressing 68
4.13 Wiegand Interface for Card Readers 69
4.13.1 Connecting different reader types 70
4.14 RS-485 Interface for Card Readers 72
4.15 RS-232 Interface for Card Readers 73
4.16 Connecting Relay Outputs 75
4.17 Connecting Analog Input Devices 82
4.18 Tamper Protection 87