32 en | Introduction Access Modular Controller 2
2020-01 | V02 | Installation manual Bosch Access Systems V.B.
Using RS-485 reader interfaces, up to eight peripheral devices can be connected to each
AMC2. The four reader interfaces are divided into two buses. Interface 1 and 2 are on one bus,
and interfaces 3 and 4 are on the other bus. With this arrangement, you can connect all
readers to one interface.
The extension interface supports up to three additional I/O boards (AMC2-8IOE, AMC2-16IE,
or AMC2-16IOE). All extension boards are controlled by the AMC2 and are freely combinable.
Notice!
This controller is currently a project version.
To Next Page
Loading...
