Bosch APC-AMC2-4R4CF - Host settings and DIP Switch Configuration

24 en | Introduction Access Modular Controller 2
2020-01 | V02 | Installation manual Bosch Access Systems V.B.
20 Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
18 Jumper for setting either voltage free relay output (“dry” mode) or looped-in voltage
from the AMC2 internal power supply (“wet” mode).
19 DIL switch for setting the board address.
20 Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
7 Jumper for setting either voltage free relay output (“dry” mode) or looped-in voltage
from the AMC2 internal power supply (“wet” mode).
8 Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.