Bosch APC-AMC2-4R4CF - 4.12 Connecting relay outputs

Access Modular Controller 2 Introduction | en 29
Bosch Access Systems V.B. Installation manual 2020-01 | V02 |
– one AMC2 controller,
– one AMC power supply,
– one AMC enclosure.
– The maximum configuration depends on the system software,
– the necessary number of APS-PSU-60 power supplies,
– the necessary number of AMC enclosures.
Figure3.33: System overview
1 = Host
2 = Ethernet
3 = AMC2-4R4
4 = RS-232 connection (for special control functions)
5 = RS-485 connection for max. two readers
6 = Wiegand connection
Figure3.34: System overview
1 = Host
2 = AMC2-4W
3 = Card reader